Lighting Up A Pre-Mounted 10mm Square Rebel LED

Demonstration showing how easy it is to use the solder to the 10mm square Rebel LEDs using standard bench top soldering tools and supplies.

Connecting Multiple 10mm Square Rebel LEDs in Series

You can power as many 10mm square LEDs in series as your driver can accommodate. Here is how to do it using standard hook up wire and soldering tools.

Lighting Up A Pre-Mounted Rebel Star LED

The 20mm hex MCPCB base makes it easy to power up a pre-mounted Rebel Star LED in just a few minutes.

Connecting Multiple Rebel Star LEDs in Series

Powering multiple Rebel Star LEDs is just a matter of connecting a single hookup wire from LED to LED to create a series connection.

Connecting The Rebel Tri-Star LED For RGB Operation

The base used for our pre-mounted Rebel Tri-Star LEDs is configured for RGB operation by default. All you need to do is to connect to each LED as demonstrated here.

Connecting The Rebel Tri-Star LED For Triple (Series) Operation

If you want to power all of the LEDs on the Rebel Tri-Star LEDs, all you need to do is to apply two "solder dots". Here is how it is done.